Audi Q3 2013 Key Programming by Lonsdor K518ISE
A distance of about 25,000 km of the 2013 Audi Q3 2.0 SUV. The car engine starts a period of time after the central channel on the left side of the veneer surface temperature is high, the customer can feel the temperature higher than the right side. Use Lonsdor K518ISE to program key
Failure analysis:
(1) Vpecker E4 comparison found that the left side of the car temperature is higher than other vehicles to check the bottom of the chassis exhaust pipe insulation board installed normal, no damage. The analysis may be the heat inside the heat exchanger shell inside the car.
(2) Launch CRP Touch Remove the warm air heat exchanger at the plaque, with a thermometer to measure the temperature of the heater outside the heat exchanger shell, higher than other cars. Hand around the shell feels hot gas overflows outwards.
(3) Lonsdork518 Remove the heat exchanger cover carefully observed that the heat exchanger and the installation of the middle of the gap between the shell, under normal circumstances should be sponge seal, in order to verify the demolition of the test drive heat exchanger cover, found There is a sponge, remove the heat exchanger and found that one end of the heat exchanger sponge missing, replace the heat exchanger after troubleshooting.
Backup EPROM
1. This function can read the device EPROM data and save in Lonsdor K518ISE;
2. For smart key, please turn off and on the ignition, and then click OK; otherwise click OK directly;
3. The system read out the part number, now is going through security certification, and loading external code;
4. Getting system data, it takes about 2 min, please be patient;
5. Read the vehicle PIN code and other info;
6. Please enter the file name to be saved;
7. EPROM data is saved.
Get Lonsdor K518ISE from eobdtool:
http://www.eobdtool.co.uk/wholesale/lonsdor-k518ise-key-programmer.html

Add key (OBD)
1. This system is suitable for directly programming smart card dealer key.
Directly add key(suitable for folding dealer key directly programming)
1. This function can directly add a dealer key to the immobilizer system, please put the new key into the coil, and connect the host to the car OBD port;
2. For a smart key, please turn xtool x100 pro and on the ignition, and then click OK; otherwise click OK directly;
3. The system read out the part number, now is going through security certification, and loading external code;
4. Getting system data, it takes about 2 min, please be patient;
5. Writing immodata, about 2 minutes, please be patient;
6. Add key complete.
Delete key
1. This function can delete an existing key;
2.The process of this function:
Step 1. Read anti-theft data Step 2. Select an existed key Step 3. Write back immodata;
3. For a smart key, please turn off and on the ignition, and then click OK; otherwise click OK directly;
4. The system read out the part number, now is going through security certification, and loading external code;
5. Getting system data, it takes about 2 min, please be patient;
6. Please select the key to be deleted;
7. System communicating, delete complete.
LONSDOR K518 is on sale